trimmer Series 7 www.braun.
off on trimmer trimmer Series 7 8
STOP 9
trimmer Series 7 STOP 10
on on on off off off release 12 off tr
off on lock 1 k loc 2 13 lo ck
1 2 s fa t c le an fa st clea n 14 new fa st c le an
er trimm 15 Serie s7
new 16 old
r me trim Series Series er relea se oil Series 7 re lease trimmer Series 7 release 17
Series 7 release Series 7 release 18 rleease
Series rele ase 70S-3 19
3 4 8 Series 7 9 10 5 on 6 trimmer trimmer 2 1 11 off 12 13 14 15 7 16 17 20 18 19 s7 rie Se r me trim 23
English STOP Our products are designed to meet the highest standards of quality, functionality and design. We hope you enjoy your new Braun Shaver. Warning Your shaving system is provided with a special cord set, which has an integrated Safety Extra Low Voltage power supply. Do not exchange or tamper with any part of it, otherwise there is risk of an electric shock.
0 q w e r t z u i o p Shaver head «lock» switch Pop-out long hair trimmer On/off switch (–) setting button (sensitive) (+) setting button (intensive) Reset button Shaver display Shaver-to-station contacts Shaver power socket Travel case Special cord set Before shaving Prior to first use you must connect the shaver to an electrical outlet using the special cord set p or alternatively proceed as below.
« « « « » » » » shaver is clean short economical cleaning required normal level of cleaning required high intensive cleaning required If the station selects one of the required cleaning programs, it will not start unless you press the start button 4 . For best shaving results, we recommend cleaning after each shave. Each cleaning program consists of several cycles, where cleaning fluid is flushed through the shaver head.
Charging information • A full charge will take about 1 hour and provides up to 50 minutes of cordless shaving time. This may vary according to your beard growth. 5-minute quick charge is sufficient for a shave. • Recommended temperature for recharging is 5°C to 35°C. Outside the recommended temperature range, the battery may not be fully charged to protect the battery from being damaged. Do not expose the shaver to temperatures higher than 50°C for extended periods of time.
Tips for the perfect shave release For best shaving results, Braun recommends you follow 3 simple steps: 1. Always shave before washing your face. 2. At all times, hold the shaver at right angles (90°) to your skin. 3. Stretch your skin and shave against the direction of your beard growth.
trim Rinsing the shaving head under running water is an alternative way to keep the shaver clean, especially when travelling: me r • Switch the shaver on (cordless) w and rinse the shaving head under hot running water. You may use liquid soap without abrasive substances. Rinse off all foam and let the shaver run for a few more seconds.
Keeping your shaver in top shape Replacing the Foil & Cutter cassette / reset To maintain 100% shaving performance, replace the Foil & Cutter cassette 8 , when the replacement symbol lights up on the shaver display z (after about 18 months) or when cassette is worn. The replacement symbol will remind you during the next 7 shaves to replace the Foil & Cutter cassette. Then the shaver will automatically reset the display.
