Oral-B Oral-B 5 modes Type 3757 99746373_D34_Japan.indd 1 02.02.
Oral-B Oral-B 2 99746373_D34_Japan.indd 2 02.02.
99746373_D34_Japan.indd 3 02.02.
Ora Oral-B A set h/min 2 1 set h/min B set h/min 5 modes t h/min set t h/min set C 24 h 4 99746373_D34_Japan.indd 4 02.02.
1 2 Oral-B 5 modes 45 s sec 5 45 s sec 45 sec 30 s ec 0 ec 4 30 ec ec sec 30 s 3 3 4 5 modes 5 5 99746373_D34_Japan.indd 5 02.02.
99746373_D34_Japan.indd 6 02.02.
99746373_D34_Japan.indd 7 02.02.
99746373_D34_Japan.indd 8 02.02.
99746373_D34_Japan.indd 9 02.02.
99746373_D34_Japan.indd 10 02.02.
4 es od 5m 1 5 modes 2 3 5 6 7 11 99746373_D34_Japan.indd 11 02.02.
99746373_D34_Japan.indd 12 02.02.
99746373_D34_Japan.indd 13 02.02.
Ora Oral-B a A set h/min 2 1 k set h/min j b i c B set d h/min e 5 modes t h/min set t h/min set f g C h 24 h 14 99746373_D34_Japan.indd 14 02.02.
English Welcome to Oral-B! specially marked areas in hospitals. Deactivate radio transmission by simultaneously pressing the on/off and mode button for 3 seconds until the radio transmission display (f) goes off. Follow the same procedure to reactivate transmission again. Before operating this toothbrush, please read these instructions and save this manual for future reference. IMPORTANT • Periodically check the cord for damage.
page 4) and push the «set» or «h/min» button. A flashing «12:00» indicates that you can now adjust the clock time. Clock time Press and hold the «set» button until «12h» is displayed. By briefly pressing the «h/min» button, you can toggle between «12h» or «24h» daytime format. Push «set» to confirm your choice. Then the hour digit starts flashing. Press the «h/min» button until the right hour appears and confirm with «set». Proceed same way to set both minute digits (picture B, page 4).
Pressure sensor If you put excessive pressure on your teeth, the red pressure sensor light (b) will light up (picture 3, page 5). Additionally, when brushing in Daily Clean or Deep Clean mode, the brushing mode will change to the «Sensitive» mode. Periodically check the operation of the pressure sensor by pressing moderately on the brush head during use.
(picture C, page 4). The adhesive tape will not work on dirt-repellent surfaces. Removing batteries Handle battery At the end of the product’s useful life, open the handle as shown, remove the rechargeable battery and dispose of it according to local environmental regulations. 4 es od 5m 1 5 modes 2 3 This product contains rechargeable batteries. In the interest of protecting the environment, please do not dispose of the product in the household waste at the end of its useful life.
99746373_D34_Japan.indd 19 02.02.
99746373/II-11 Japan/GB 99746373_D34_Japan.indd 20 02.02.