Specifications

9
cap (8) has been developed as an optional
attachment to be placed on the epilation
head (2).
Please be aware that especially in the
beginning, these areas are particularly
sensitive to pain. Therefore, we recommend
that you select speed setting «I» for the
first few epilation processes.
With repeated usage the pain sensation
will diminish. For more comfort, ensure
that the hair is at the optimum length of
2–5 mm.
Before epilating, thoroughly clean the
respective area to remove residues (like
deodorant). When epilating the underarm,
keep your arm raised up so that the skin
is stretched and guide the appliance in
different directions. As skin may be more
sensitive directly after epilation, avoid
using irritating substances such as deo-
dorants with alcohol.
5 Facial epilation
For removing any unwanted hair from
the face or other sensitive areas, use the
precision cap (9) as an optional attachment
to be placed on the epilation head (2).
For the first few usages, we recommend
that you select speed setting «I» in order to
get used to the epilation sensation in those
sensitive areas.
Prior to epilation, we recommend cleaning
the skin with alcohol to promote good
hygiene.
When epilating the face, stretch the skin
with one hand and slowly guide the
epilator with your other hand the direction
of the switch.
Overheating protection
As a safety feature to avoid the unlikely
event of the appliance overheating, it may
happen that the red low charge light shines
permanently for 8 seconds and then the
appliance turns off automatically. In this case,
turn the switch back to the position «0» and
let the appliance cool down.
6 Cleaning the epilation head
Regular cleaning ensures better perform-
ance.
a Brush cleaning:
Remove the cap and brush it out.
Thoroughly clean the tweezers from the
rear side of the epilator head with the
brush dipped into alcohol. While doing so,
turn the tweezer element manually. This
cleaning method ensures best hygienic
conditions for the epilation head.
b Cleaning under running water:
After each wet usage, clean the appliance
under running water.
Remove the cap. Hold the appliance with
the epilation head under running water.
Then press the release button (6) to
remove the epilation head (2).
Thoroughly shake both, the epilation
head and the appliance to make sure that
remaining water can drip out. Leave both
parts to dry. Before reattaching, make sure
that they are completely dry.
B Using the shaver head
attachment
a OptiTrim comb
b Shaver foil
c Trimmer
d Release buttons
e Trim/shave selector
f Cutter block
g Shaver head base
96667187_SE7681WD_CEE_S6-124.indd 996667187_SE7681WD_CEE_S6-124.indd 9 13.01.14 13:5113.01.14 13:51
CSS APPROVED Effective Date 20Jan2014 GMT - Printed 22May2014 Page 9 of 124