Instruction Manual

3
Now that the speakers are talking to one another, you
need to get them talking to your device, follow the
steps in section 1 to pair your device with one (not
both) of your BRAVEN BRV-X units.
When you turn off either of the BRAVEN BRV-X
speakers while connected in True Wireless, both
speakers will turn off. When you’re ready to rock again
in True Wireless, press the power button on both
BRAVEN BRV-X speakers within 5 seconds of each
other. The BRAVEN BRV-X speakers will automatically
reconnect to each other and to the previously
connected device. You will hear two beeps indicating
True Wireless is reestablished.
Note: True Wireless technology only supports
one active Bluetooth® connection to your device
at the same time. If any other Bluetooth® device
(other than the paired BRAVEN BRV-X speakers) is
simultaneously connected to your device, the BRAVEN
BRV-X audio will distort. If distortion occurs, power
down all other Bluetooth® devices in range of your
phone/tablet, other than the Braven BRV-X. Refresh the
Bluetooth® connections on your phone/tablet by turning
Bluetooth® off and then back on. True Wireless is now
reestablished. To break the True Wireless connection,
press and hold the battery check button until the
connection stops.
For troubleshooting and tutorial videos, please go to
www.BRAVEN.com/TrueWireless
WATER RESISTANT FEATURES
The BRAVEN BRV-X is IPX5 Water Resistant. BRAVEN
BRV-X speakers are not intended to be submerged in
water, but are resistant to rainfall, water jets, and water
splashing.