Operation Manual
GB
ECopyright Bravilor Bonamat B.V.
IX
version 1.0
Installation
D The maximum acceptable ambient temperature with which a good operation can be guaranteed is 40C.
D Consider damage caused by freezing. Never place the machine in rooms in which the temperature
can drop below 0C. After all, with normal use there will always be water in the machine.
D Do not turn over the machine, move it upright.
D Never install the machine in places where water is sprayed or sprinkled.
D Never install the machine in front of entrances, exits or passageways intended for emergency
services.
D Place the machine on a sufficiently solid, flat surface close to a water connection, water discharge
and an earthed electrical power outlet.
D Leave sufficient space at the back and front of the machine for maintenance and repair purposes.
D Connect the machine to a readily accessible, manually operated water tap, so that the water supply
can easily be turned off.
D Connect the machine to the electrical supply in such a way that the connection of all phases and
neutral can be easily disconnected . The minimum distance between the disconnected contacts
have to amount 3 mm at least.
D Ensure that the machine is correctly earthed.
D Always observe local rules and standards when installing this machine.
Use
D Inspect the machine before use and check for damages.
D Protect the machine against water and moisture. Do not allow the machine to become wet by
spraying and never submerge the machine in water.
D Keep the operating controls free from dirt and grease.
D Never use sharp objects to operate the push buttons.
D Note that during use some parts of the machine become very hot.
D Disconnect the electrical supply and the water supply when the machine will not be used for long
periods. Clean the machine following the instructions in chapter 5.. Discharge the water (w 4.1.6).
Maintenance and repairing failures
TIP
− In this document a clear distinction is made between maintenance activities that can be carried
out by the daily user and activities which are exclusively reserved for users with limited authority
(operator) and especially trained users with more extensive authority (principal).
− Repair and maintenance activities not included in this document are always reserved to service
mechanics.
D If the mains lead is visibly damaged, it has to be replaced by a qualified service technician.
D Observe the given maintenance intervals. Overdue maintenance can lead to high repair costs and
may cause guarantee claims to become invalid.
D Do not carry out any maintenance activities concerning the machine before having it protected
against unintentional coming into operation. In such cases disconnect the electrical supply.
D Never leave the machine during maintenance activities.
D For cleaning the machine only use the cleansing agent and descaler recommended by the
manufacturer.
D Always wear suitable facial protection and gloves while working with cleansing and descaling
materials. Wash your hands after using these materials.
D Prevent damage of the machine caused by spilled descaler solution. Remove spilled solution as
quickly as possible and follow the previously mentioned safety instructions.