Operation Manual

GB
version ECopyright Bravilor Bonamat B.V.8 1.0
− If the water temperature has been set below
the maximum (97 C, at sea level) (§ 7.3.6.1)
the above no longer applies.
WARNING
n Do not touch the cover during the automatic
boiling point approach at the risk of burning.
G
H
I
J
KL
M
N
Fig. 6 Activating the HW system
3.2.2.2 Flushing the coffee−making
system
D Place the filter unit (T.) on the coffee container
(Y.).
D Turn the spray head (D.) above the hole in the
cover (U.) of the filter unit (T.).
D Switch the ON/OFF switch (P.) on.
− The indicator lamp in the switch lights up.
The default options appear in the display
(fig. 7 ).
D Push the selection key for amount 2 (H.).
− A signal sounds. The coffee−making
process is started. The selected amount
flashes in the display.
As soon as the hot water supply through the
spray head has stopped, the filter pan in the
display starts flashing. This means that the
dripping−on time has started. (Only when the
dripping−on time is set). The dripping−on time is
standard set to 2 minutes. After the dripping−on
time has terminated, a signal sounds (3 short
beeps) indicating that the coffee−making process
has finished.
D Tap the water through the coffee tap (AB.).
D Turn the spray head above the filter unit of the
other container.
D Repeat the above steps for the other coffee
container.
After that the coffee−making system is ready for
use (chapter 4.)
G
H
I
J
KLM
N
Fig. 7 Display with the default options