Operation Manual

GB
version 1.0ECopyright Bravilor Bonamat B.V.
9
4. DAILY USE
While the machine is in use, the factory default
settings may appear to be incorrect or insufficient
for the circumstances under which the machine is
used. These settings can be changed − by
properly trained and authorized users − in
conformity with the instructions in § 7.3.
The present chapter (4.) only describes therefore
the normal, daily use of the machine by users
with limited authority: making and tapping coffee.
Maintenance activities for the daily user are
described in § 5.1. Periodic maintenance
activities for users with limited authority are
described in § 5.2.
4.1 Operation
CAUTION!
− Inspect the machine before use and check for
damages.
− Protect the machine against water and
moisture. Do not allow the machine to
become wet by spraying and never submerge
it in water.
− Keep the operating controls free from dirt and
grease.
− Never use sharp objects to operate the push
buttons.
− Note that during use some parts of the
machine become very hot.
− When the machine is not to be used for a
long period, disconnect it from the electrical
supply and shut off the water supply.
4.1.1 Making coffee
G
H
I
J
KLM
N
Fig. 8 Starting screen
D Switch the ON/OFF switch (P.) to ON.
− The indicator lamp in the switch lights up.
The default options appear in the display
(fig.8 ).
D Check whether the coffee container (Y.) is
empty. Discharge this, if necessary, through
the coffee tap (AB.).
D Place the filter paper in the filter cone (V.) (if
available) or in the filterpan (W) and add the
required amount of ground coffee. For the
recommended ground filter coffee and filter
paper (quality and quantity), see § 2.6).
D Place the spray cover (U.) on the filter pan
(W.).
D Place the shackle disc with mixer pipe (X.) and
the filter unit (T.) on the coffee container.
D Select the desired amount of coffee by
pressing one of the selection keys (G.−J.).
− The selected amount flashes on the display.
TIP
− If the selection keys do not include the
desired amount, then with the help of key
(M.) or (N.) another amount can be
selected. Subsequently press selection key
(J.). A signal sounds and the coffee−making
process has started.
D Make sure that the container and the spray
head are in the right position.
− If not, the part concerned starts flashing on
the display and the coffee making is
blocked.
D Put the part in the right position and the
blockade is lifted.