Operation Manual
GB
version 1.0ECopyright Bravilor Bonamat B.V.
11
4.1.5 Starting the hot water
system
D Switch the ON/OFF switch (P.) to ON.
− The indicator lamp lights up. The default
options appear in the display (fig.9 ).
D Press the activating key (L.) for the hot water
system.
− The boiler is now filled with water and
heated up to the set temperature. The
flashing display (O.) shows the actual rising
water temperature.
D Tap the water as soon as the set water
temperature has been reached.
TIP
− The hot water system can be stopped by
pressing the activating key (L.) again. The
temperature disappears from the display and
the boiler is no longer filled or heated up.
− Only if the maximum water temperature
has been set (§ 7.3.6.1) every 10 minutes
the hot water in the boiler is heated with
about 2C extra in order to get a better hot
water quality (in particular for making tea).
This can prevent that during daily use the
boiling point is reached causing steam to
come out of the hot water cover (C.).
− If the water temperature has been set
beneath the maximum (§ 7.3.6.1), the
above no longer applies.
WARNING
n Do not touch the cover during the automatic
boiling point approach at the risk of burning.
4.1.6 Tapping hot water
D Place a jug or pump thermos under the hot
water tap (R.) and pull the handle forward.
TIP
− The tap can be locked in the open position by
pushing it fully backwards against the spring
pressure.