Operation Manual

GB
version ECopyright Bravilor Bonamat B.V.18 1.0
7.1.2 Once−only time settings
for making coffee
These pre−programmed ”time settings” can be
changed for once−only use.
This is done as follows:
D Press selection keys (M.) and (N.)
simultaneously and hold them down for about 2
seconds.
− The current day and time appear for a
moment on the display (fig.13 ).
− After this the next time setting appears on
the display (fig.14 ).
D Press programming key (G.).
− The position to be changed flashes beside
the programming key on the display.
D Press selection key (M.) and (N.) to select
another day, if necessary (§ 7.3.7.2, table 10 ).
D Confirm this by pressing the confirmation key
(L.).
− The desired day has been set now.
D Press programming key (I.) to change the
number of litres.
D Press selection key (M.) and (N.) to select
another amount, if necessary.
D Confirm this by pressing the confirmation key
(L.).
− The desired amount has been set now.
D Now press the programming key (J.) to set the
time.
− The two first positions beside the
programming key are flashing.
D Select with selection key (M.) and (N.) the
desired hour.
D Press again the programming key (J.) to set
the minutes.
− The two last positions beside the
programming key are flashing.
D Select with selection key (M.) and (N.) the
minutes.
D Press the confirmation key (L.).
− The desired time has been set now.
D If these settings are good, then press
programming key (H.).
− OFF will be changed to ON.
D Now press the confirmation key (L.).
− The clock in the display starts flashing and
the system will make coffee at the set time.
− When the coffee−making cycle has been
finished, the setting returns to the default
setting.
TIP
− When the container and/of the spray head
are not in the correct position, a signal
sounds and flashes on the display.
− Also this selected time setting has been
protected, so that no one can cancel the
setting between times, see the previous tip at
§ 7.1.1.
− Permanent changing of the default settings is
described in the extended programming mode
§ 7.3.