Operation Manual

GB
version 1.0ECopyright Bravilor Bonamat B.V.
19
7.2 The limited programming menu
Below a description is given of how operators
with limited authority, after having entered the
operators’ PIN code, can read day and total
counters, put these to zero and start the
descaling programme.
TIP
− For the limited programming menu a
operators’ PIN code is required, see the fold
out sheet at the back of these operating
instructions.
− Enter the operators’ PIN code. The
programme starts in the carousel (fig. 12 ) of
the operators’ menu at § 7.2.1, ”Day counter
coffee−making system”.
− When a wrong PIN code has been entered,
wait a little while until the initial screen
re−appears on the display. Re−enter the PIN
code.
− Press the selection key (N.) to go clockwise
to the next setting (§ 7.2.8), see also fig. 12 .
− Press the selection key (M.) to
counter−clockwise to the next setting (§ 7.2.2).
By pressing a selection key several times, the
entire carousel (fig. 12 ) can be gone through.
− The settings are described in the order of the
carousel, counter−clockwise (fig. 12 ).
− With the red stop key (K.) the programming
can always be interrupted and stopped. The
programme then returns to the users’ menu
(§ 7.1).
− When nothing happens in the programming
menu for 20 seconds, the programme returns
to the users’ menu (§ 7.1). Non−confirmed
settings are not saved.
− When the symbol appears in the
menu, the setting can be set to zero by
simultaneously pressing both selection keys
(M.) and (N.).
− The day and total counters only give the
amounts in litres. Even if the amount at
§ 7.3.1 has been set in cups, jugs or
us−gallons.