Operation Manual
GB
version 1.0ECopyright Bravilor Bonamat B.V.
21
7.2.3 Starting descaling
programme
coffee−making system
− Make sure that the spray head is in the
correct position above the empty container
with empty filter unit.
− Desolve 100 g of descaler in 0.75 litre
lukewarm water (about 40C). Stir the
descaling solution, so that it is well desolved.
− When during the descaling programme a
signal sounds, an operation is to be carried
out. Finish the operation by pressing the
confirmation key (L.).
− When the level blocks on the display start
flashing, the coffee container is to be
emptied.
G
H
I
J
KLM
N
Fig. 18 Starting the descaling programme
coffee−making system
D After having entered the operators’ PIN code,
press selection key (M.) twice.
− The descaling programme appears on the
display (fig. 18 ).
D Press programming key (G.).
− The symbol dP starts flashing and the enter
symbol appears on the display.
D Press confirmation key (L.) to start the
descaling programme.
− A flashing hammer symbol appears on the
display.
− The waterreservoir is boiled empty and this
water flows into the coffee container.
− A signal sounds and the level blocks on the
display flash, indicating that the container
must be emptied.
TIP
− Stopping the programme
Within 5 seconds (when the stop symbol
above key (K.) still flashes):
D press key (K.).
− After 5 seconds (when the stop symbol key
above key (K.) has stopped flashing):
D Hold programming key (G.) down until
fig. 18 re−appears on the display.
− After pouring in the descaler solution, the
programme can not longer be aborted by
pressing the red stop key.
D Empty the coffee container through the tap (AB.).
D Press the confirmation key (L.) to confirm that
the container is empty.
− A signal sounds, the hammer symbol flashes
and a funnel appears on the display (fig. 19 ).
G
H
I
J
KLM
N
Fig. 19 Coffee−making system asks for descaling
solution
D Remove the plug of the filling hole for descaler
solution (B.).
− The filling hole of the coffee−making system
is found behind the spray head (D.).
D Place the special funnel in the filling hole and
carefully pour the descaler solution into the
filling hole.
D After pouring in the descaler solution, press the
confirmation key (L.).
− The resevoir is boiled empty to let the
descaler solution run through the flow
element.
− The first level block appears on the display
and the hammer symbol flashes (fig. 20 ).
− The coffee container is filled with water.
− When the signal sounds and the level blocks
on the display flash, the containers must be
emptied.