Operation Manual

GB
version 1.0ECopyright Bravilor Bonamat B.V.
27
7.3 The extended programming menu
Below a description is given of how users with
extended authority (principal), after having
entered the PIN code, can view and adjust all
settings. First read this section to see which
settings can be made.
TIP
− The extended programming menu needs a
principal user PIN code.
− Enter the principal user PIN code to access
the programming menu. The programme
starts in the carousel (fig.12 ) of the extended
users’ menu with § 7.3.1, ”Setting total
amount of water”.
− When a wrong PIN code has been entered,
one should wait a while until the initial screen
re−appears on the display. Enter the PIN
code again.
− Press selection key (N.) to go clockwise to
the next setting (§ 7.3.2), also see fig.12 .
− Press selection key (M.)  to go counter−
clockwise to the next setting (§ 7.3.19). By
pressing a selection key several times the
entire carousel can be browsed through
(fig.12 ).
− The settings are described in the order of the
carousel, clockwise (fig.12 ).
− On the display the value to be adjusted is
each time indicated by flashing.
− When an enter symbol  appears on the
display, the setting can be confirmed by
pressing the confirmation key (L.).
− With the red stop key (K.) the changing of the
setting can be interrupted and cancelled. By
pressing again the red stop key (K.) the
programming is left and the programme returns
to the users’ menu (§ 7.1). The change is not
saved.
− When after confirming a changed setting no
further changes are to be made, the
programming menu can be left by pressing the
stop key (K.). The changes are saved and the
programme returns to the users’ menu (§ 7.1).
− When for 20 seconds no activities have taken
place in the programming menu, the
programme returns to the users’ menu
(§ 7.1). Non−confirmed settings are not
saved.
− When the symbol appears in the
menu, the setting can be set to zero by
pressing simultaneously both selection keys
(M.) and (N.).
7.3.1 Setting total amount of
water
The total amount of water to be delivered can be
adjusted, as always a certain amount of water
remains behind in the coffee filter. This amount
can differ by the use of different kinds of coffee
and grinds. The default setting is 6% extra water.
In table 4 the setting options are given:
Model Factory setting Setting range
B5HW 5,3 litres 4,8−5,8 litres
B10HW 10,6 litres 9,6−11,6 litres
B20HW 21,2 litres 19,2−23,2 litres
Table 4 Adjusting total amount of water
G
H
I
J
KL
M
N
Fig. 30 Total amount of water
D After having entered the principal user PIN
code fig.30 appears on the display.
D Press programming key (J.).
− The L with the associated value beside the
programming key starts flashing.
D Press selection key (M.) or (N.) to select the
desired extra amount of water (table 4 ).
− The enter symbol  appears on the display.
D Press confirmation key (L.) to confirm the
adjustment.
D Press selection key (N.) to go to the next
setting (§ 7.3.2) or press stop key (K.) to exit
the programming menu.