Operation Manual

GB
version ECopyright Bravilor Bonamat B.V.32 1.0
7.3.6 Settings hot water
system
The hot water temperature can be set between
88_C − 3_C under the boiling point. The default
temperature is _Celsius, but this can also be set
to _Fahrenheit.
The automatic boiling point determination
programme can be reset (§ 7.3.6.2). This can
only be done when the water has not yet
reached 85_C (at sea level). Otherwise drain a
little water and refill with cold water (till maximum
6,5 cm under the rim of the kettle).
7.3.6.1 Setting temperature and
degrees Celsius or Fahrenheit
G
H
I
J
KL
M
N
Fig. 40 Setting the temperature
D Press, after having entered the principal user
PIN code, 3 time selection key (N.) until
fig.40 appears on the display.
D Press programming key (G.).
− The position beside the programming key
starts flashing.
D Press selection key (M.) or (N.) to select the
desired temperature.
− On the display beside the programming key
(I.) there is the ”C” of Celsius.
D If desired, press programming key (I.) to
change the temperature into Fahrenheit. The
”C” changes into ”F”.
− The enter symbol  appears on the display.
D Press confirmation key (L.) to confirm the
adjustment.
D Press selection key (N.) to go the next setting
(§ 7.3.7.1) or press stop key (K.) to exit the
programming menu.
7.3.6.2 Resetting the automatic
boiling point determination
programme
D Press, after having entered the principal user
PIN code, 3 time selection key (N.) until
fig. 40 appears on the display.
D Press for about 20 seconds programming key
(H.).
− The automatic boiling point determination
programme is activated.
− A zero starts flashing on the display.
− The programme takes about 15−25 minutes.
This depends on the temperature of the
water in the kettle.
TIP
− If the water in the kettle is cold, drain it
completely and pour hot water (ca. 70 C)
into the kettle till maximal 6,5 cm under the
rim of the kettle. This will shorten the time of
the automatic boiling point determination
programme till about 15 minutes.
− When the automatic boiling point
determination programme has finished,
the program returns to the users menu, the
starting screen appears in the display, see
fig. 8 , § 4.1.1. Also the temperature has
been reset to the default setting (96 C, at
sea level).
D Press selection key (N.) to go the next setting
(§ 7.3.7.1) or press stop key (K.) to exit the
programming menu.