RLX HOT–WATER MODULE 700.403.
Table of contents 1. Modules 3 and 7 (hot water) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . GB 1.1 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.1.1 1.1.2 1.2 1.3 General description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Main components . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
MODULES 3 AND 7 (HOT WATER) 1.1 Introduction 1.2 In this document, the specific information for the above–mentioned module is discussed. Please also thoroughly read the general user instructions. 1.1.1 General description These modules are designed for the preparation of hot water. As soon as the module is switched on using the ON/OFF switch, the water will be heated. The water is drawn off using the draw–off tap. 1.1.2 Main components 1 1 2 2 3 3 4 5 Fig.
GB 1.4 Daily use 1.4.1 Operating panel A D B C Fig. 2 Control panel hot–water modules A. descaling indication Will flash to show that the machine needs to be descaled. B. [–] button Push button to change the values during programming. C. [+] button Push button to change the values during programming. D. display Displays the temperature of the water in _C. 1.4.2 Operation 1.4.2.1 Preparing hot water 1. Switch on the module. – The boiler is filled and the water is heated up.
Maintenance 1.6.1 General GB 1.6 D See § 1.5 of the “General user instructions”. 1.6.2 Descaling WARNING n Always wear gloves and protective facial gear during the descaling procedure. n Remain near the machine during the descaling process. 1. First read the “General user instructions” § 1.5.3. 2. Make sure there is a sufficiently large container (min. 5 litres) to collect the liquid. 3. Switch off the module. 4. Drain off the water using the hot water draw– off tap. 5.
GB 1.7 Correcting malfunctions D See §1.6.1 of the “General user instructions”. 1.7.1 Malfunctioning analysis hot–water module LIST OF MALFUNCTIONS Symptom: Possible cause: Actions: 1. On the display, ‘00’ is flashing constantly. The machine will start up the boiling programme. Wait until the boiling programme is finished. 2. When switching on the module, the display will light up and immediately afterwards will go off. The boiling programme is interrupted.