RLX COFFEE MODULE AND WIDE–BODY MODULE 700.403.
Table of contents 1. Modules 1, 5 and 6 (coffee) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . GB 1.1 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.1.1 1.1.2 1.2 General description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Main components . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
MODULES 1, 5 AND 6 (COFFEE) 1.1 Introduction In this document, the specific information for the above–mentioned module is discussed. Please also thoroughly read the general user instructions. 1.1.1 1.2 Technical data 1.2.1 Water system D See table 1 for additional technical information about the coffee modules. Volume recommended amount of coffee hourly capacity 1 1,7 litre 60–85 gr. 14 litre 5 2,0 litre 70–100 gr. 13 litre 6 1,9 or 65–95 gr. 2,2 litre 75–110 gr.
GB 1.3 First use 1.3.1 Flushing 1. Place an empty filter pan in the machine. 2. Switch on the module. – The indicator lamp in the switch will be illuminated, all the lights and the display will be illuminated for a moment, and a short audible signal is generated. – The display will indicate the set standard number of cups. 3. Press the 1/0–button. – An audible signal will sound, the indicator lamp will light up, and the process is started. 4.
1.4.2.4 Making tea – To use loose tea, a special tea filter pan, with sieve, is available. – If you use teabags, you can use a normal filter pan. Place the tea bags in the filter pan, or hang them in the jug. TIP – When making tea, never use the filter pan, a glass jug or airpot that has been used for making coffee. 1.5 Programming the module The operating panel is also used for programming purposes. During programming, the 1/0–button serves to lower certain values, and the –button to raise them.
GB 1.6 Maintenance 1.6.1 General 1.6.3 D See §1.5 of the “General user instructions”. 1.6.2 Cleaning the gauge glass (module 5) 1 3 2 ÎÎÎ WARNING n If the coffee container is not completely empty (sometimes difficult to check if the gauge glass is dirty), coffee can flow out over the hands when the gauge glass is removed. 1. Make sure that the coffee container is completely empty. 2. Remove the cover. 3. The gauge glass is clamped with an O–ring at the bottom of the gauge glass holder.
Correcting malfunctions GB 1.7 D See §1.6.1 of the “General user instructions”. 1.7.1 Malfunctioning analysis coffee module LIST OF MALFUNCTIONS Symptom: Possible cause: Actions: 1. Descaling signal is flashing. Too much scale in the machine. Run the descaling sequence on the machine, see §1.6.3. 2. After descaling, the descaling g signal g is still fl hi flashing. Still too much scale in the machine. Descale the machine once more. 3. The filter pan runs over.
GB 2. MODULE 2 (WIDE BODY) 2.1 Introduction In this document, the specific information for the above–mentioned module is discussed. Please also thoroughly read the general user instructions. 2.1.1 General description This is a hot plate, which will keep the jug of coffee (or tea) warm. 2.1.2 Main components 2.2 Operation 1. Place the jug with contents on the hot plate. 2. Switch on the module. 2.3 Maintenance D See §1.5 of the “General user instructions”. 2.