Unit installation

143: Set Offset for RBI-1 or RLC-ICM ................................. 14-15

144: Set Offset and Frequency Readback Styles ........................... 14-16

145: Set Power Level for RBI-1 ....................................... 14-17

146: Set PL Frequency for RBI-1 or RLC-ICM ........................... 14-18

147: Turn PL Encode Off/On for RBI-1 or RLC-ICM ....................... 14-19

148: Turn PL Decode Off/On for RBI-1 or RLC-ICM ...................... 14-19

149: Recall Band, Frequency & Offset for RBI-1 or RLC-ICM ................ 14-20

150: Recall All RBI-1 or RLC-ICM Settings .............................. 14-20

151: Turn Radio Power On or Off for RBI-1 .............................. 14-21

152: Goto Radio Memory Channel for the RBI-1 .......................... 14-22

141: Control/Recall RBI-1 Output Lines ................................. 14-23

Chapter 15: Serial Controlled (HF) Radio Support .............................. 15-1

HF Radio Interfacing ................................................. 15-1

HF Radio Control: ................................................... 15-2

195: Configure HF Mode ............................................. 15-4

196: Configure HF Radio ............................................. 15-5

197: Set/Recall Transmit/Scan Band Edges ................................ 15-7

198: HF Mode Enable ................................................ 15-9

HF Remote Base Keypad Definition: ......................... 15-10

199: Enter HF Command (w/o being in HF mode) ......................... 15-16

Chapter 16: Special Audio Routing Commands ................................ 16-1

037: Set Audio Routing Variable for Commands In a Macro .................. 16-2

038: Kill All Responses Following This Command ........................... 16-3

065: Restore Audio Routing Variable (Undo 037 and 038) .................... 16-4

039: Recall the Ports in the Current Audio Routing Variable ................... 16-5

050: Set Up or Recall Default Audio Routing Variables ...................... 16-6

Chapter 17: Special Control Commands ...................................... 17-1

035: Remotely Reset the Controller ...................................... 17-2

078: Set Command Entry Options for a Port ............................... 17-3

079: Recall Command Entry Options for a Port ............................. 17-5

080: Execute Command by Number ...................................... 17-6

164: Recall Software Version .......................................... 17-8

165: Reset COP Watchdog Timer ....................................... 17-8

166: Display Status Screen ............................................ 17-9

167: Do Nothing .................................................... 17-9

014..019: Not Currently Used ......................................... 17-10

049: Not Currently Used ............................................. 17-10

052: Not Currently Used ............................................. 17-10

067..069: Not Currently Used ......................................... 17-10

081, 081: Not Currently Used ......................................... 17-10

089: Not Currently Used ............................................. 17-10

096..099: Not Currently Used ......................................... 17-10

117..118: Not Currently Used ......................................... 17-10

153..154: Not Currently Used ......................................... 17-10

168: Not Currently Used ............................................. 17-10