Unit installation

6-12

044: Set Up DTMF Regenerate Parameters: Not Active

This command allows you to set up the DTMF regenerate parameters for each attached port. You

may need to use this command to slow your DTMF tones down if a scanning DTMF decoder is on

any of the attached systems that you want the RLC-3 to control.

<044> p aaaa bbbb

Parameters:

- 044 is the default command name.

- P is the selected port (1..8)

- AAAA is the length of the DTMF sequence in 10mS steps (0000..9999)

- BBBB is the pause between DTMF digits in 10mS steps (0000..9999)

Default:

Both length and pause set to 100mS lengths