Unit installation

6-25

182: Select DVR Type

This command tells the RLC-3 what type, if any, DVR is installed. Some DVR commands will not

work correctly if this command has not been executed. If no DVR is installed, this command

should be used to tell the controller that (or it may cause problems such as the tranmitter coming up

or staying up when it shouldn't).

Number DVR Selected

<182> 0 No DVR Installed

<182> 1 Large DVR Installed

<182> 2 Small DVR Installed

170: Record and Play Audio Test

This command makes the DVR start recording. When you unkey or press a DTMF digit to stop

recording, it automatically plays it back. This is useful for testing the DVR and for checking how

your signal sounds into the repeater. To use this command enter 170 and unkey, then key up and

talk or enter "170 D" and and start speaking immediately. When through speaking, unkey and your

recording will be played back immediately. The track is automatically erased after it is played back.

<170>

171: Record DVR Track (non-prompted)

This command makes the DVR start recording a track. To use this command enter Command 171

TTT D or unkey. Either way, you message will be recorded and stored in track TTT.

<171> t Record track 0..9

<171> tt Record track 00..99

<171> ttt Record track 000..260

Please note that a DVR track that has been recorded before must be erased before it can be

recorded again. This is to avoid accidently recording over an existing message.

Parameters:

- 171 is the default command name

- T, TT, TTT is the DVR track number (1..3 digits, track 0..260)