Unit installation

6-32

184: Playback a Small DVR Message(s)

This command allows you to send one or more DVR messages. It will be sent to the ports that are

in the audio routing variable at the time this command is executed (for more information about

audio routing, see Appendix A).

<184> s Playback a single message 0..9

<184> ss Playback a single message 00..34

<184> ss..ss Playback multiple messages 00..34

Parameters:

- 184 is the default command name.

- SS is the DVR slot number, two digits per slot

Notes:

DVR messages can be intermixed with synthesized voice messages and the RLC-3 will

make sure that they are sent in the right order. For example, you could write a macro that

would speak your call sign using the synthesized voice, then use the DVR to speak "Link

Up". This also means that if the synthesized voice is in use, the DVR will have to wait until

it is finished to send its message, even if the messages are unrelated.

If a single message was recorded across multiple slots, it should be played back by

specifying only the beginning slot number. For example, if you recorded a six second

message with the Command 183 10 15 D or unkey, you can play back the whole message

by entering Command 184 10 D or unkey.

185: Erase Small DVR Message(s)

This command allows you to delete one or a range of DVR messages. If an erased message is later

played, it will sound like a short pause. There is no way to "un-erase" a message once it is erased.

<185> ss Erase a single message

<185> ss..ee Erase multiple messages

Parameters:

- 185 is the default command name.

- SS is the DVR slot number to erase, two digits per slot

- EE (optional). If EE is not specified, only one slot will be erased. If EE is specified, the

DVR will delete slots SS through EE.

Voice Response: "Clear <ss> <ee>"