Unit installation

Command List by Number

000: Connect one Port to another Port ...........................................2-4

001: Monitor one Port from another Port .........................................2-5

002: Disconnect one Port from another Port .......................................2-6

003,004: Recall a Port's Connections ............................................2-7

007, 008: Configure, Check DTMF Mute on a Selected Port ...................... 3-3, 3-4

009: Recall Entire Controller's Audio Crosspoint ..................................2-11

010: Re-Program Command Names .............................................5-5

011, 012: Recall Information about a Command Name ...............................5-8

013: Recall Radio Port Card Conditions .........................................2-12

014..019: Not Currently Used ...............................................17-10

020: Program a Selected Timer ................................................4-2

022: Start a Timer .........................................................4-21

023: Stop a Timer .........................................................4-22

024: Set Up RS-232 Serial Baud Rates ...........................................7-3

025: Sets the Time of Day Clock ..............................................4-23

026: Recall the Time of Day Clock in Male Speech .................................4-23

027: Recall the Time of Day Clock in Female Speech ...............................4-23

028: Sets the Date .........................................................4-24

029: Recall the Date ........................................................4-25

030: Send a CW Message .....................................................6-2

031: Send a DTMF Sequence ..................................................6-3

032: Send Serial Message out the Main Serial Port ..................................7-5

033: Send Serial Message out Radio Card's Serial Port ...............................7-7

034: Send Serial out Radio Card's Serial Port by ASCII Code .........................7-8

035: Remotely Reset the Controller ............................................17-2

036: Send a Voice Message ...................................................6-4

037: Set Audio Routing Variable for Commands In a Macro .........................16-2

038: Kill All Responses Following This Command .................................16-3

039: Recall the Ports in the Current Audio Routing Variable .........................16-5

040: Send One or Two Tone Sequence ..........................................6-6

041: Courtesy Beep Enable/Disable for a Selected Transmitter .........................6-9

042: Set CW Speed for a Selected Port .........................................6-10

043: Set CW 2-Tone Frequencies for a Selected Port ..............................6-11

044: Set Up DTMF Regenerate Parameters: Not Active ............................6-12

045: Setup Beacon Table ....................................................19-2

046: Start Beacon ..........................................................19-3

047: Cancel Beacon ........................................................19-3

048: Start Beacon Using English Words .........................................19-4

049: Not Currently Used ...................................................17-10

050: Set Up or Recall Default Audio Routing Variables .............................16-6

051: Start Dial-Tone .......................................................6-13

052: Not Currently Used ...................................................17-10

053: Program a Single Command Macro Sequence .................................8-5

054: Recall Macro Contents ..................................................8-6

055: Delete Macro .........................................................8-7

056: Append a Command to a Macro ...........................................8-7