Unit installation

7-8

034: Send Serial out Radio Card's Serial Port by ASCII Code

This command does the same thing as command 033, but lets you send any serial character rather

than just the ones you can find on your DTMF pad or keyboard. You specify the characters by

entering their ASCII codes in decimal, three bytes per digit. For a table of the ASCII codes, see

Appendix G.

<034> p aaa..aaa

Parameters:

- 034 is the default command name.

- P is the radio card to send the message out of

- aaa is the ASCII code of a digit to be sent out to the RS-232 port on a radio card. See

Appendix G for ASCII codes.

Voice response:

There is no voice response for this command

Notes:

• Use 033 instead of this command if you can - it doesn't make you look up ASCII codes.

• To change the baud rate, see command 024.