Unit installation

RLC-3 V1.80 Copyright © 1998 Link Communications Inc. 9/17/98
057: Copy a Macro ......................................................... 8-7
058: Delete a Command in a Macro ............................................ 8-8
059: Insert a Command in a Macro ............................................. 8-8
060: Set Up Serial Port Options ............................................... 7-4
061: Disconnect all Ports from a Radio Port ..................................... 2-13
062: Change the Beginning of Command Names ................................... 5-7
063: Send a Polite Voice Message ............................................ 6-14
064: Send a Polite Voice Message and if Interrupted... ............................. 6-15
065: Restore Audio Routing Variable (Undo 037 and 038) .......................... 16-4
066: Send a Voice Message Using English Words .................................. 6-5
067..069: Not Currently Used ............................................... 17-10
067: Set Macro Data Length ................................................. 8-21
070: Configure a Repeater for Preaccess ......................................... 9-2
071: Configure a Link for Preaccess ............................................ 9-3
072: Disable Preaccess Requirement for a Port .................................... 9-4
073: Recall Ports with Preaccess Requirement .................................... 9-4
074: Allow Access To a Port that Requires Preaccess ............................... 9-4
075: Set Stop Access Conditions .............................................. 9-5
076: Recall Stop Access Conditions ............................................ 9-6
077: Isolate a Port from the Rest of the System ................................... 9-6
078: Set up Force-Execution Functions for a Port ................................. 17-3
079: Recall Force-Execution Set up's for a Port .................................. 17-5
080: Execute Command by Number ............................................ 17-6
081, 081: Not Currently Used ............................................... 17-10
082: Set Up a Scheduler Event ............................................... 10-2
083: Recall a Scheduler Event ............................................... 10-5
084: Enable/Disable a Scheduler Event ......................................... 10-6
085: Enable/Disable IDing a Port ............................................. 11-4
086: Recall Which Ports have ID's Enabled ...................................... 11-4
087: Set Random or Rotating Pending IDs ...................................... 11-5
088: Recall Random or Rotating Pending ID Selection ............................. 11-5
089: Not Currently Used .................................................. 17-10
090: Read Whether Input Line is High or Low ................................... 12-5
091: Execute Input Line High or Low Macro .................................... 12-5
092: Enable/Disable Input Line Alarm .......................................... 12-6
093: Turn Output Line On .................................................. 12-7
094: Turn Output Line Off .................................................. 12-7
095: Recall Whether Output Line is On or Off ................................... 12-8
096..099: Not Currently Used ............................................... 17-10
096: Control or Recall Extended Output Lines ................................... 12-24
100: Read Analog Input Line ................................................. 12-9
101: Set Resolution For Analog Input ......................................... 12-10
102: Set Conversion Ratio For Analog Input ................................... 12-12
103: Calibrate an Analog Input .............................................. 12-15
104: Set an Analog Alarm .................................................. 12-16
105: Set Analog Alarm Hysteresis ........................................... 12-17
106: Enable/Disable an Analog Alarm ......................................... 12-19
107: Recall Analog Lines in Alarm ........................................... 12-19
108: Recall Analog Line Configuration ........................................ 12-20