Unit installation

8-4

200..499: Execute an Automatic Macro

These commands allows you to manually recall program macro sequences. These sequences are

executed automatically by the controller to send ID's, courtesy beeps, alarm analog lines, recall

input conditions, etc. These macros are programmed the same way as user macros, but are

automatically called by the controller when certain events occur. You can also execute them

manually by entering the command name (200 through 499). This is useful for testing the macros

to make sure that they are programmed they way you want them to be. They are described in the

“Automatic Macro Explanations” section at the end of this chapter.

<200>..<499>

Parameters:

- 200..499 is the default command name.

500..999: Execute a User Macro

These commands allow you to execute user macro sequences. These macro are not used by the

controller for any specific purpose, so you can use them for any purpose.

<500>..<999>

Parameters:

- 500..999 is the default command name.