Unit installation

RLC-3 V1.80 Copyright © 1998 Link Communications Inc. 9/17/98
109: Configure Wind Speed Reading ..........................................12-23
110: Configure the Autopatch ................................................13-6
111: Manual Off Hook .....................................................13-8
112: Normal Forward Dial ...................................................13-8
113: Forward Dial with no Long Distance Checking ...............................13-9
114: Hang up the Autopatch ................................................13-11
115: Possibly Hang up the Autopatch .........................................13-11
116: Set / Recall the Predial Digits and Timing ..................................13-12
117..118: Not Currently Used ...............................................17-10
119: Set Allowed Numbers Table Slot .........................................13-13
120: Recall Allowed Numbers Table Slot ......................................13-13
121: Set Nuisance Numbers Table Slot ........................................13-14
122: Recall Nuisance Numbers Table Slot ......................................13-14
123: Test Dialing Tables ...................................................13-15
124: Set Autodial Slot .....................................................13-15
125: Recall Autodial Slot ...................................................13-16
126: Send Predial Digits / Callsign for Autodial Slot? .............................13-16
127: Enable/Disable an Autodial Slot ..........................................13-17
128: Set Full or Half-Duplex Patch Audio for a TX ...............................13-18
129: Recall Full or Half-Duplex Patch Audio for a TX .............................13-10
130: Block Command Execution From Port .....................................5-10
131: Allow Command Execution From Port .....................................5-10
133: Set up Reverse Patch ..................................................13-20
134: Access Reverse Patch Control Mode ......................................13-22
135: Answer Reverse Patch .................................................13-22
136: Set up Reverse Autopatch Ring ..........................................13-24
137: Autodial Only ........................................................13-9
138: Direct SPI Send out of Radio Card's Serial Port ................................7-9
139: Setup RLC-Icom Interface ...............................................14-8
140: Set Port for RBI-1 or RLC-ICM .........................................14-12
141: Set Band Unit for RBI-1 or RLC-ICM ....................................14-13
141: Control/Recall RBI-1 Output Lines .......................................14-23
142: Set Frequency (and Offset) for RBI-1 or RLC-ICM ...........................14-14
143: Set Offset for RBI-1 or RLC-ICM ........................................14-15
144: Set Offset and Frequency Readback Styles ..................................14-16
145: Set Power Level for RBI-1 .............................................14-17
146: Set PL Frequency for RBI-1 or RLC-ICM ..................................14-18
147: Turn PL Encode Off/On for RBI-1 or RLC-ICM .............................14-19
148: Turn PL Decode Off/On for RBI-1 or RLC-ICM ............................. 14-19
149: Recall Band, Frequency and Offset for RBI-1 or RLC-ICM .....................14-20
150: Recall All RBI-1 or RLC-ICM Settings ....................................14-20
151: Turn Radio Power On or Off for RBI-1 ....................................14-21
152: Goto Radio Memory for RBI-1 ..........................................14-22
153..154: Not Currently Used ...............................................17-10
155: Enable or Disable PTT for a Port ..........................................2-14
156: Recall Which PTT are Enabled ...........................................2-14
157: Set/Recall Event Trigger ................................................20-2
158: Default Event Trigger Action .............................................20-2
159: Enable/Disable Event Trigger ............................................20-2