Unit installation

8-19

Macro 404 is used to speak "Call complete at <time>" when you hang up the patch. It is

automatically programmed when the controller is reinitialized. You can delete it and program your

own autopatch off message if you wish.

Macro Definition

404 Called when the Autopatch is hung-up.

Macro 405 is called when the DTMF cover tone is requested. It normally sends a 440 Hz tone

using command 040. It can be set back to the default beep by entering: "053 405 020 030 0440".

Any other tone, cw character, or voice message could also be used, although you will want to keep

the length fairly short.

Macro Definition

405 DTMF cover tone macro

Macro 406 is called when a user logs on using his password. First his callsign is spoken, then this

macro is called. It is normally programmed to speak "control up". It can be programmed to speak

other messages if you wish.

Macro Definition

406 User Logon Message

Macro 407 is called a user tries to log on but gets the password wrong. It normally says "fail".

Macro Definition

407 User Logon Fail Message

Macro 408 is called when a user logs off. First his callsign is spoken, then this macro is called. It

is normally programmed to speak "control down".

Macro Definition

408 User Logoff Message