Unit installation

9-2

070: Configure a Repeater for Preaccess

This command sets up a port to be a preaccess repeater. To execute commands from the repeater,

key up, press the '*' key and enter the command. The command will be executed immediately,

without waiting for you to unkey. This allows you to execute multiple commands in sequence

without unkeying after each one. Also, when you pressed the star key, you were removed from any

other repeaters or links you may have been connected to. In other words, the '*' puts you into a

local control mode. This mode will expire if you unkey for 8 seconds (see command 076).

If you key this repeater and do not press the '*' key, you will not be in the local control mode and

will be connected to other ports normally (see Commands 000, 001 and 002).

<070> p

Parameters:

- 070 is the default command name.

- P is the port to make a preaccess repeater