Unit installation

9-6

076: Recall Stop Access Conditions

This command allows you to recall the conditions that will stop access on a port. See Command

075 for descriptions of the conditions.

<076> p

Parameters:

- 076 is the default command name.

- P is the port for which to recall the stop access conditions (1..8)

077: Isolate a Port from the Rest of the System

This command breaks the audio and ptt links between the specified port and all other ports in the

system until the preaccess timer (which it starts) runs out. It temporarily overrides but does not

change the crosspoint connections you may have set with Commands 000 and 001. It is useful for

isolating a port while you enter local control commands without the tones going down any

connected links. It is usually called from the preaccess macro of a port configured as a repeater.

This macro is usually named '*', the local control key.

<077> p

Parameters:

- 077 is the default command name.

- P is the port for which to allow access (1..8)