Unit installation

12-6

092: Enable/Disable Input Line Alarm

This command allows you to turn on input line alarms that will occur whenever an input line goes

high or low. When the alarm occurs, it will execute the input line high or low macro. Note that

these are the same macros that get executed by Command 091 whenever the input line is read. The

high and low alarms can be enabled or disabled separately.

<092> b l a c

Parameters:

- 092 is the default command name.

- B is the I/O board number (1..2)

- L is the input line number (1..8)

- A is 1 for the high alarm, 0 for the low alarm

- C is 1 to enable the alarm, 0 to disable it

Note:

There is currently no command recall whether the input line alarm is turned on or off.