Unit installation

12-7

093: Turn Output Line On

This command allows you to turn an output line on. The outputs are active low open collector

drivers, so on means that they apply a ground to that output. Off means that the output is open, or

not hooked to anything.

<093> b l Turn a single output line on

<093> b l..l Turn multiple output lines on

Parameters:

- 093 is the default command name.

- B is the I/O board number (1..2)

- L is the output line number (1..8)

Notes:

To provide customized messages when turning output lines on or off, use a macro that both

executes this command and the speak voice message command (036).

094: Turn Output Line Off

This command allows you to turn an output line off. The outputs are active low open collector