Unit installation

12-20

108: Recall Analog Line Configuration

This command recalls all kinds of information about an analog line's conversion, resolution,

calibration, alarm points, hysteresis, alarm enabled/disabled status, etc. It intended to aid in setting

up the analog subsystem, not as a user command.

<108> b l

Parameters:

- 108 is the default command name.

- B is the I/O board number (1..2)

- L is the analog input line number (1..8)

Description of the voice response:

"I/O ?" - which I/O board we are referring to (1..2)

"analog ?" - which analog input on the I/O board we are referring to (1..8)

"0 volts is ?" - the lower calibration point

"5 volts is ?" - the upper calibration point

"calibrate ?" - how many units the calibration changes the reading

"low alarm ?" - the low alarm point

"high alarm ?" - the high alarm point

"h ?" - the amount of hysteresis

"low alarm ?" - whether alarm is on or off

"high alarm ?" - whether alarm is on or off