Unit installation

13-8

111: Manual Off Hook

This command connects the port from which the command is executed to the autopatch without

dialing any numbers. Touch tones from your radio can be used to dial numbers without DTMF

regeneration. This is usually used only for testing, because it doesn't regenerate your DTMF digits,

it doesn't allow you to block long distance numbers, and it usually causes an error message when

you dial a number. The error message may be generated because the controller can't tell whether

you are entering a command (such as to hang up the patch) or dialing a number, so it treats the

number as a (usually invalid) command; you can just ignore the error message. Command 114 can

be used to hang up the patch.

<111>

Parameters:

- 111 is the default command name.

112: Normal Forward Dial

This is the normal autopatch up command you would make available to your users if you want an

open autopatch. If the number you enter is 3 digits or less, it dials that autodial number. If it is

longer, it checks it against the dialing tables described at the beginning of this autopatch section and

if it passes, dials that number.. Command 114 can be used to hang up the patch.

<112> sss Autopatch using an autodial memory slot

<112> d..d Autopatch using user entered number

Parameters:

- 112 is the default command name.

- SSS is the autodial slot number (1..3 digits)

- D..D is the phone number you want to dial

Notes:

• The longest number that can be dialed with the command is eleven digits, because that is the

longest number that can be specified in the allowed number table. If you need to dial longer

numbers, use Command 113.