Unit installation

16-7

Default:

Commands entered from a receiver are sent to whichever port entered the command. All

others default to sending messages out transmitter 1.

Notes:

When you enter a command on the serial port to change the audio routing variable for

commands entered from the serial port, the routing is changed before the response to this

command is generated. For example, if you turn the responses off by entering "050 0", you

won't get a voice response. If you enter "050 0 1" to turn them back on for port 1 (the

default), you will get a voice response out port 1.

Command 114 (the autopatch hangup command) can not be controlled with this command,

as it sets its own audio routing to speak the hang up message to all of the ports that are

listening to the patch, not just to the one that hung it up.

See Appendix A for more information about audio routing variables in general, commands

037, 038 and 065 for information about routing audio within a macro.