Unit installation

19-2

045: Setup Beacon Table

This command allows you to set up the beacon table. It is this table that controls what happens

when a beacon is started. The different slots in the table can be used to alert you of different

things, or they can be used together (when N is set to 01..50) to alert you in several different ways,

such as by radio and by telephone.

<045> SS Recall slot SS

<045> SS MMM XX TTTT NN T D..D Set slot SS

Parameters:

045 is the default command name.

SS = beaconing table slot number to set up/recall: 01..50. If this is the last parameter

entered, will recall the current settings of the slot in the table.

MMM = macro/command number to do

XX = number of times to do it

TTTT = time to wait between in seconds between calls to MMM. If the message spoken in

command/macro MMM uses the controller's synthesized voice or DVR and it

takes longer than this timer is set for, the controller will wait until the message is

done. This timer should be set fairly short (less than 5 seconds) when T=1

(autopatch), so when you answer the phone you won't have to wait a long time

before you hear the message.

NN = next beaconing table slot to do (01..50), or

00 = stop after done with this slot

T = type of beacon to do

0 = beacon out radio port(s)

D..D = list of radio ports, audio routing

1 = beacon out of autopatch

D..D = phone number to dial