Unit installation

B-8
RLC-3 V1.80 Copyright © 1998 Link Communications Inc. 9/17/98
Special Word Pairs:
Most of the following words 925 xxx - callsign of user xxx
need to be followed by (as set with cmd 191)
another word number that 926 xxx - callsign of user
specifies which one to do: logged onto port xxx
which analog line to read, 927 xxx - callsign of user
which command to execute, being paged with
which time zone to use, etc. command 132
For example, to read analog 3
as an S-meter, you would
want to speak word 920
followed by word 003.
Analog lines 1..8 are on I/O
board #1, 9..16 are on I/O
board #2.
920 xxx - read analog 1..16
as S-Meter. To obtain
a current reading, must
use an event trigger to
clear the high value
each time the COR
goes active. For
example “157 000
500" followed by “053
500 038" and “056 500
160 111" will reset the
high value for I/O
board 1 analog line 1
whenever the COR for
port 1 goes active.
921 xxx - read analog 1..16
as a Direction: N, NE,
E, SE, S, etc.
922 xxx - execute command
xxx (up to command
900 or so, may not go
all the way to 999).
Will not happen until
this word is actually
spoken.
923 xxx - speak 24 hour time
in male voice adding
xxx hours. Can use to
speak the time for any
time zone.
924 xxx - same as above in
female voice