Unit installation

1-15

Error 211 - Command does not exist

This error is simular to error macro 200 except it occurs when a listed command that is not

enabled, is called. The command name exists but the command does not exist.

Error 212 - Bad Autopatch Number

You tried to enter a number in the autopatch that is invalid or blocked.

Error 213 - General Autopatch error

There is a general autopatch error that just occurred. Refer to the command you are

executing and verify the format or the autopatch is not configured (See Command 110)

Error 214 - User requested is disabled

This error is encountered if a user that is disabled tries to log-on to the system. A nice

voice message indicating the user is not enabled is a good used for this macro.

Error 215 - Digital Voice Recorder (DVR) is busy

This error is spoke if the DVR is currently busy and the requested DVR function can not be

processed.

Error 216 - Macro is full

This error indicates a macro position if full. No more commands can be added to the

specific macro.

Error 217 - HF Error

This error indicates that the last digits entered were not a valid HF command. It will usually

occur when you are in HF mode (see command 198). You will probably want to disable this error

message by deleting the contents of macro 217: "055 217" to avoid getting an error message every

time you enter an HF command wrong.

Error 218 - Reserved

Error 219 - Reserved