Unit installation

RLC-3 V1.80 Copyright © 1998 Link Communications Inc. 9/17/98
Chapter 10: Scheduler .................................................... 10-1
How the Scheduler Works: ............................................ 10-1
082: Set Up a Scheduler Event ......................................... 10-2
083: Recall a Scheduler Event .......................................... 10-5
084: Enable/Disable a Scheduler Event .................................... 10-6
Chapter 11: The ID System ................................................ 11-1
How the ID's Work: .................................................. 11-1
Polite Voice ID's: .................................................... 11-1
To Program Your Own ID's: ........................................... 11-2
More about Programming ID's: ......................................... 11-2
ID Timing: ......................................................... 11-3
085: Enable/Disable IDing a Port ....................................... 11-4
086: Recall Which Ports have ID's Enabled ................................ 11-4
087: Set Random or Rotating Pending ID's ................................ 11-5
088: Recall Random or Rotating Pending ID Selection ....................... 11-5
Chapter 12: I/O Board .................................................... 12-1
About the I/O Board: ................................................. 12-1
Logical Input Lines .................................................. 12-1
Logical Output Lines: ................................................ 12-1
Analog Input Lines: ...................................... 12-2
I/O Board Pin-Out ................................................... 12-4
Analog Input Lines ....................................... 12-4
Logical Input Lines ....................................... 12-4
Latched Output Lines ..................................... 12-4
090: Read Whether Input Line is High or Low ............................. 12-5
091: Execute Input Line High or Low Macro .............................. 12-5
092: Enable/Disable Input Line Alarm .................................... 12-6
093: Turn Output Line On ............................................ 12-7
094: Turn Output Line Off ............................................ 12-7
095: Recall Whether Output Line is On or Off .............................. 12-8
100: Read Analog Input Line ........................................... 12-9
101: Set Resolution For Analog Input ................................... 12-10
102: Set Conversion Ratio For Analog Input .............................. 12-12
Custom Analog Conversion Ratios: .......................... 12-13
103: Calibrate an Analog Input ........................................ 12-15
104: Set an Analog Alarm ............................................ 12-16
105: Set Analog Alarm Hysteresis ...................................... 12-17
106: Enable/Disable an Analog Alarm ................................... 12-19
107: Recall Analog Lines in Alarm ..................................... 12-19
108: Recall Analog Line Configuration .................................. 12-20
160: Clear Analog High/Lows ......................................... 12-21
161: Set Analog Smoothing Factor ..................................... 12-22
109: Configure Wind Speed Reading .................................... 12-23
096: Control or Recall Extended Output Lines ............................. 12-24