Caution: You must read this before you proceed.
Label Description QTY A Chair Back 1 B Chair Seat 1 C Front Legs 2 Description QTY ① Dia. M8 Bolt: 90mm(L) 4 ② Dia.
Before Beginning Assembly: Unpack all the parts for a clear overview Pack A for locking the back panel of the seat to the horizontal panel of the backrest: Four Dia.M8 Bolt:90mm(L)+one Dia. M8 Blot:65mm(L)+five Flat Washer+five Spring Washer Pack B for Locking the Front Legs to the front corner blocks of the seat: Four Dia.
Step 1 Chair Seat Chair Back Place the chair back(A) on a soft surface to avoid any scratches or damages to the product. REMOVE the non-woven fabric from under the chair seat, take out the front legs and hardware. 2 3 1 Step 2 3 2 1 Put the chair back( A) onto a flat table or panel,align the positioning dowels on the chair seat with the holes located on the chair back-panel and chair-seat panel.
Step 3 With the chair bottom up, place the seat surface on a flat table top as shown in picture 1 . Insert each front leg completely vertically into each seat frame corner,PRESS FIRMLY DOWN with your hand until there is no gap between the front leg and the seat cushion. WARNING!! DO NOT POSITION THE FRONT LEG AS SHOWN IN PICTURE 2 ,WHICH SHOWS THE CHAIR BACK STAYS AGAINST THE GROUND AND THE FRONT LEGS LIES horizontally.
Place the chair on a LEVEL SURFACE to see if it is wobbling. If it is, hold the chair with your two hands and hang it at 30cm to 50cm height from the ground. Drop it freely and vertically with the four legs falling on the ground at the same time. Test again to see if the chair is wobbling on the LEVEL SURFACE. Now tighten all the bolts untill the chair is not wobbling on the LEVEL SURFACE. WARNING IF CHAIR IS NOT STABLE ,IT COULD LEAD TO DAMAGING THE PRODUCT.