Installation & Assembly
IMPORTANT:
• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.
• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!
• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!
PREPARING FOR INSTALLATION
Remove all of the contents from the carton. See the important notes above. Shut o the power
at the circuit breaker and completely remove the old xture from the ceiling, including the old
mounting strap.
From the parts bag remove the mounting strap assembly. One end of nipple (F) should be
attached to mounting strap (A) with washer (C) and hex nut (D) in place. The other end should
have canopy loop (H) attached. Attach mounting strap (A) to the junction box using mounting
screws (B) and a screwdriver. Tighten securely. Unscrew canopy loop collar (I) from canopy loop
(H). Pass canopy (G) over the mounted canopy loop to test the height. Approximately half of the
canopy loop’s exterior threads should be exposed, and the canopy loop collar should t snugly
onto the canopy loop. Remove canopy (G) and adjust the height of nipple (F) and canopy loop
(H) until the desired height is reached.
CLEANING TIPS
Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn o the light and wipe down the
xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture.
For Customer Service, contact
the place of purchase.
FINISHING THE INSTALLATION
Push canopy (G) up to the ceiling. Slide canopy loop (H) and canopy loop collar (I) up beneath the canopy. Tightly thread canopy loop collar (I) onto
canopy loop (H) to secure canopy (G) in place.
Install light bulb (not provided) in accordance with the xture’s specications. Do not exceed the maximum recommended wattage. Position
the arms. If the decorative twists (R) are loose, use the small tool (Q) to tighten.
Your installation is complete. Turn on the power and test the xture.
ASSEMBLING THE FIXTURE
Top loop (L) and washer (M) are on the wires, but not attached. Place washer (M) onto nipple (N)
and twist top loop (L) onto the threads. By measuring, determine the correct number of chain
links needed for proper hanging height. If necessary, use a pair of pliers to open and remove any
excess chain. Attach chain connectors (K) to each end of chain (J) before attaching one end of
the chain connector/chain to top loop (L). Close the chain connector. Connect the other chain
connector (K) to canopy loop (H). Feed the xture’s wires up through top loop (L) then through
chain (J) (every three links or so). Pull the wires until taut. Gently slide canopy loop collar (I) and
canopy (G) onto the chain/wires.
CONNECTING THE WIRES
Have an assistant support the xture’s weight while completing the wiring. Cut away excess wire.
Thread the xture’s wires through canopy loop and nipple. Attach the xture’s wires to the power
supply wires from the junction box. Connect black to smooth/black/transparent (L) wire; white to
ribbed/white/transparent (N) wire; ground to ground (green or copper). Twist the ends of the wire
pairs together, and then twist on a wire connector. Make sure all twists are in the same direction.
If there is no ground wire (green or copper) from the junction box, locate ground screw (E) on
mounting strap (A) and wrap the xture ground wire around the green ground screw (E). Use a
screwdriver to secure ground screw (E) onto the mounting bracket/mounting strap. Tuck all wires.
A
C
D
E
F
G
H
I
J
B
L
M
K
N
O
P
Q
R
Assembly Instructions