Installation & Assembly

Installation Instructions for

Secure the mounting plate to the junction box.

Install the weatherproof strips onto the edges of the diffuser, then install the diffuser onto the brackets on the fixture and

secure it in place using the diffuser screws.

Install the bottom and top covers and secure them in place using the cover washers and screws.

Connect the fixture ground wire to a suitable ground in accordance to local electrical codes.

Connect the white wire to the neutral power line wire with a wire nut.

Connect the black wire to the hot power line wire with a wire nut.

Mount the fixture base onto the mounting plate and secure it with the fixture screws.

For wet locations, caulk around the base of the fixture with waterproof construction sealant.

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

Altron Outdoor Wall

1.0

WB1862-WB1863-WB1864-LED

W 1862, WB1863,WB1864-LEDB

Outdoor

JUNCTION BOX

MOUNTING

PLATE

TOP COVER

FIXTURE SCREW

DIFFUSER

WEATHERPROOF STRIP

EDGE

DIFFUSER SCREW

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing compliantNEC

junction boxes.

This product is safety listed for wet locations.

For a complete list of dimmers, visit out website at www.Feiss.com

BOTTOM COVER

BRACKET

COVER SCREW

COVER WASHER

PAGE 1
Installation Instructions for WB1862-WB1863-WB1864-LED Altron Outdoor Wall WB1862, WB1863,WB1864-LED 1.0 Outdoor GENERAL PRODUCT INFORMATION: CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is safety listed for wet locations.
PAGE 2
ATTENTION : RISQUE D'INCENDIE Ce produit doit être installé conformément au code d'installation en vigueur par une personne familière avec la construction et l'exploitation du produit et les risques qu'il entraîne. Utiliser les conducteurs d'alimentation supérieure à 90° c.
PAGE 3
PRECAUCIÓN: RIESGO DE INCENDIO Este producto debe instalarse de acuerdo con el código de instalación aplicable por una persona familiarizada con la construcción y operación del producto y los riesgos que conllevan. Utilizar conductores de suministro mínimo 90° c.
PAGE 4
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 160077 800.969.3347 www.Feiss.com © 2017 Feiss.All rights reserved.The "Feiss" graphic is a registered trademark of Feiss. Feiss reserves the right to change specifications for product improvements without notification.