Caution : You must read this before you proceed Table Label Description QTY A Table Top 1 B Leg 4 C Connector 1 Description QTY ① Wrench 1 ② Bolt (M6*20mm) 25 ③ Washer 25 ④ PE Cap 9 Label Picture Picture Page 1 OF 5
Before Beginning Assembly: Overview This Table has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Table parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
Step 1 Open the carton and place all the parts onto a clean, non-marring surface. Attach Leg(B) to Table Top(A) using Bolts(②) and Washers(③) with Allen Key(①). Note: Please only assemble the outside Bolts, as the pictured above. Do not fully tighten all the Bolts. Repeat the same process with the remaining three Legs(B). Step 2 Attach Connector(C) between Legs(B) using Bolts(②) and Washers(③) with Allen Key(①) as pictured. Do not fully tighten all the Bolts.
Step 3 Finally attach Legs(B) to Table Top(A) using Bolts(②) and Washers(③) with Allen Key(①) at the inside mounting positions. Do not fully tighten the Bolts. Step 4 Now fully tighten all Bolts at all joints in a sequential manner. Put the PE Caps(④) on the Bolts(②) on the Connector(C) by hand.
Step 5 Stand the Table up. Place the Table on a level surface to check for wobbles. If the Table wobbles, adjust the Levelers on the bottom of the Legs to make it level. Step 6 Your Table is ready for use. This Table can only be used on a flat, level surface.
Do not put hot items directly on furniture surface Do not clean furniture with harsh cleansers or polish. To obtain the longest lifespan of your outdoor prodcts, minimizing exposure to direct sunlight is recommended. Children should not climb or jump on the furniture. Do not write on furniture without a padded barrier to protect the surface. To obtain the longest lifespan of your outdoor products, avoid extended and lengthy exposure to rain, snow, and direct sunshine.
