Instruction for Assembly

5. In openings of Ø15mm on the faces of sidewalls (1,2)
insert couplers eccentric fast installation (B-02) according to the
figure 6.
6. Fasten plates (N-01) at distance of 150 mm from the
bottom and upper edge of sidewalls
(1, 2) by means of screws of Ø4x16
mm (E-02) according to pic. 6. The
ledge of a plate (N-01) concerning
forward edge of sidewalls (1, 2) is
equal to 5 mm.
7. On partitions (13, 15) fix
ball guides (R-02/2) according to
headdress of Ø3 mm with the help
of screws Ø3х16 mm (E-01)
(picture 7).
! Twist screws in the openings
extended horizontally "", for a
possibility of further adjustment
of a box in the direction
forward/back.
8. On false-panels (7,8) (two
openings - from above and from
below), on socles (19,20) and a slip
(18) fix the nipple goniometer (J-01)
in openings of Ø5 mm by means of
an euroscrew of Ø6,3x13 mm (E-
07) according to the picture 8.
9. On the faces of false-
panels (7, 8) twist the screw of the
eccentric of fast installation (S-02)
according to the picture 8 in
openings Ø5 mm (two openings
disposed closer to the center of a detail).
10. On the false-panel (7, 8) fix overlays of loops (L-01/1)
according to a headdress of Ø3 mm with the help of screws of
Ø4х16 mm (E-02) (picture 10).
! Separate loops (L-01) on a slip and a case (L-01/1 and L-01/2
respectively) turned off the screw
connecting them and removed a
slip.
11. Fix cases of loops (L-01/2)
to doors (16, 17) by means of
screws of Ø4x16mm (E-02)
according to the picture 11.
12. Fix a socle (19, 20) to a
low horizontal wall (6) by means of
an euroscrew of Ø6,3x13mm (E-07)
through the nipple goniometer (J-01)
it is similar to the picture 8.
13. Connect a middle board
(3), top (18) and partitions (13, 15)
between themselves clamp
eccentrics (V-01) (picture 9).
14. Connect the received
design above, sidewalls (1, 2) and a
low horizontal wall (6) between
themselves and twist eccentrics (V-
01) (picture 9).
15. Attach a cover (4) to sidewalls (1, 2) and to partitions
(13, 15) then clamp eccentrics (V-01) (picture 9).
16. Fasten a slip top (18) to a cover (4) by means of an
euroscrew of Ø6,3x13 mm (E-07) through the nipple goniometer
(J-01).
17. Check squareness of a framework on diagonal
according to the picture 12.
picture 7
picture 8
picture 9
R-02/ 2
E-01
C-02
E-07
J-01
B
5мм
Е-02
L-01(02)/ 1
picture 10
picture 11