Owner's Manual

Assembly Steps:
Note: Do not fully tighten bolts until assembly is completed and alignment is correct.
Step 1. Assemble the connector (D) to the table leg (B) with bolts (AA) and washer (DD)
as shown in figure 1.
Figure 1
Step 2. Carefully place the table top (A) upside down on a non-abrasive surface.
Step 3. Assemble the table legs (B) to the table top (A) with bolts (BB) and washer (DD)
as shown in figure 2.
Page 6 of 7
Figure 2