Owner Manual

7
8. ATTACHING THE FAN
BLADES
1. Fasten blade to motor using the flat washers,
lock washers and screws supplied. (Fig. 12)
2. Repeat process with other blades. Tighten each
screw and make sure the blade is straight.
NOTE: This fan is supplied with two types of
blades for installation. Follow the step below to
installing your fan blade properly.
The inner holes are for 3 blades. (for
PA3-CR)
The outer holes are for 5 blades. (for
PA5-CR)
Figure 12
Figure 13
Blade
Screw
Flat washers
Lock washers
9. ATTACHING THE
MOUNTING PLATE
Step 1. Remove 1 of the 3 screws from the
mounting ring and keep it for future use. Loosen
the other 2 screws. (Do not remove)
Step 2. Place the key holes on the mounting plate
over the 2 screws previously loosened from the
mounting ring, turn mounting plate until it locks in
place at the narrow section of the key holes.
Secure by tightening the 2 screws previously
loosened and the one previously removed. (Fig.
13)
Screws
Mounting ring
Mounting
plate