Installation & Assembly
FINAL ASSEMBLY
1. Install a 60 watt max. Medium base type "A" bulb (not included) into each socket.
Installation of a bulb exceeding 60 watts maximum could result in fire, serious bodily injury or death.
2. Restore power after installation is fully complete. Your fixture is ready for use.
ASSEMBLY INSTRUCTION:
READ AND SAVE THE INSTRUCTIONS.
THIS PRODUCT IS FOR INDOOR USE ONLY! OUTDOOR USE COULD RESULT IN SHOCK, FIRE OR SERIOUS BODILY INJURY OR DEATH. ALL
WIRING MUST BE DONE IN ACCORDANCE WITH NATIONAL AND LOCAL ELECTRIC CODES. IT IS STRONGLY RECOMMENDED THAT YOU USE A
QUALIFIED ELECTRICIAN.
THIS FIXTURE MUST BE MOUNTED TO A UL LISTED OUTLET BOX CAPABLE OF SUPPORTING THE FIXTURE. FAILURE TO
FOLLOW THIS REQUIREMENT COULD RESULT IN THE FIXTURE FALLING CAUSING SERIOUS BODILY INJURY OR DEATH.
1. Disassemble the cross bar from canopy by removing the two screw provided with the canopy. Drill the expanding nut into
ceiling and attach the cross bar to the ceiling using the two screw provided with the mounting hardware pack.
2. Wrap Supply Ground Wire of lamp assembly and Supply Ground Wire of junction box together around screw of Crossbar.
Tighten the ground screw with a flat head screwdriver.
3. Connect the white or ribbed fixture wire to the white supply wire in the outlet box using the TWIST-ON wire connectors
provided. Connect the black or smooth fixture wire to the black supply wire in the same manner.
4. Tuck the wires carefully inside the outlet box. Spread the electrical splices so that the black wires are on one side of the outlet
box and the white wires are on the other side. Next raise the canopy to the ceiling and attach back to cross bar by using two
screw provided with the canopy.
TO AVOID SHOCK, FIRE OR SERIOUS BODILY INJURY OR DEATH IT IS VERY IMPORTANT THAT THE ELECTRICITY
SERVICING THE FIXTURE IS TURNED OFF BEFORE AND DURING INSTALLATION.
Outlet Box
Black or Smooth
Fixture Wire
White or Bibbed
Fixture Wire
Canopy
Crossbar
Ground Screw
Green Ground Wire
1-4 Screw,
Supplied with
Mounting Hardware Pack
Page 2 of 6






