Installation & Assembly

If xture is provided with ground wire, connect xture
ground wire to outlet box ground wire with wire
connector (Not provided) aer following the above steps.
Never connect ground wire to black or white power
supply wires.
4) Make wire connecons. Reference chart below for
correct connecons and wire accordingly.
Connect Black or Red
Supply Wire to:
Connect White Supply
Wire to:
Black White
*Parallel cord (round &
smooth)
*Parallel cord (square &
ridged)
Clear, Brown, Gold or
Black without Tracer
Clear, Brown, Gold or Black
with Tracer
Insulated wire (other
than green) with copper
conductor
Insulated wire (other
than green) with silver
conductor
*Note: When parallel wire (SPT
1 & SPT 2) are used. The neutral
wire is square shaped or ridged
and the other wire will be round
in shape or smooth (See illus.)
Neutral Wire
5) Push xture to wall. Be sure not to pinch wires between
wall and canopy of xture.
6) Place the lockwasher [G] onto the mounng screws
before threading the lockup knobs[F] onto the screws
and ghten to secure xture to wall.
7) Carefully raise glass[H] to the xture. Slip the opening
over the socket and t the glass against the socket.
8) Thread socket ring[I] onto socket. Tighten socket ring to
secure glass in place. (DO NOT over ghten.)
9) Insert recommended bulb(s) (Not supplied).
GREEN GROUND
SCREW
CUPPED
WASHER
OUTLET BOX
GROUND
FIXTURE
GROUND
DIMPLES
WIRE CONNECTOR
OUTLET BOX
GROUND
GREEN GROUND
SCREW
FIXTURE
GROUND
a
b
Fixture Diagram
Parts List
Cauons
CAUTION – RISK OF SHOCK –
Disconnect Power at the main circuit breaker panel or main
fusebox before starng and during the installaon.
WARNING:
This xture is intended for installaon in accordance
with the Naonal Electrical Code (NEC) and all local code
specicaons. If you are not familiar with code requirements,
installaon by a cered electrician is recommended.
Installaon Instrucons
[A] Mounting
Strap
[B] Canopy
[C] Mounting
Screws
[D] Outlet Box
[E] Strap
Mounting
Screws
[F] Lockup Knobs
[G] Lockwasher
[H] Glass
[I] Socket Ring
1) Find the appropriate threaded holes on mounng
strap[A] that align with hole distance in canopy[B].
Thread mounng screws[C] into threaded holes starng
from outlet box[D] side.
2) Aach mounng strap to outlet box with strap mounng
screws[E]. Mounng strap can be adjusted to suit
posion of xture.
3) Grounding instrucons: (See Illus. a or b).
a) On xtures where mounng strap is provided with a
hole and two raised dimples, wrap ground wire from
outlet box around green ground screw, and thread
into hole.
b) On xtures where a cupped washer is provided,
aach ground wire from outlet box under cupped
washer and green ground screw, then thread into
mounng strap.
Installaon Instrucons (connued)