Specifications

Chapter3
Installation
America’sFavoriteStovesSince1980 Page13

Flashing Installation – Insert Models

1. Afterinstallingthestoveinthe
fireplace,pullthestovetowardthe
hearthjustacoupleofinches.
2. Removethetwoscrewsoneachside
ofthestoveusinga3/32”allen
wrench.
3. WiththePhilipsheadscrews
providedinstalltwoscrewsoneach
sideofthe
stoveandonlypartially
tighten.
4. Insertthesideflashingoverthescrew 
headandallowtodropdown.
5. TightenPhilipsheadscrews.
6. Repeatforotherside.
7. InstalltwoPhillipsHeadscrewsinthe
topofeachsideflashingandonly
partiallytighten.
8. Slidethetopflashing
ontothescrews
andtightenscrews.
9. Pushstoveandflashingintofireplacesothattheflashingsalignagainstthefaceofthehearth.



Mobile or Manufactured Home Requirements

NOTE:Notapproved forCanadianMobileHomeInstallations.Thesedirectionsonlyapplyformobile home
installationswithintheUnitedStatesofAmerica.

WARNING:DONOTINSTALLINASLEEPINGROOM.

NOTE:The outside air kit MUST be used (See “OUTSIDE AIR KIT”), and a spark arrestor may be required.
Check
withyourlocalbuildingofficials.

NOTE:DOUBLEWALLPIPEISREQUIREDFORTHEEXHAUST.SinglewallpipeisNOTauthorizedforMobileor
ManufacturedHomeInstallations.

The W3100FS must be securely fastened to the floor of the mobile (manufactured) home using the mounting
boltholeslocatedinthepedestalofthe
W3100FS.Useonlytheholesprovide d.

If the optional blower is used the W3100FS must be grounded to the steel chassis of the home with 8 Ga.
Copperwireusingaserratedorstarwashertopenetratepaintorprotectivecoatingtoensuregrounding.

CAUTION: DURING THE INSTALLATION OF THIS
 STOVE, DO NOT COMPROMISE THE STRUCTUARL INTEGRITY
OFTHEMOBILE(MANUFACTURED)HOMEWALL(S),FLOORORCEILING.
