Instruction manual

Breckwell 13

MOBILE HOME INSTALLATION

Special Mobile Home Requirements

 CONSULT YOUR MUNICIPAL BUILDING DEPARTMENT OR FIRE OFFICIALS ABOUT

PERMITS, RESTRICTIONS AND INSTALLATIONS REQUIREMENTS IN YOUR AREA.

 WARNING! - DO NOT INSTALL IN A SLEEPING ROOM.

 CAUTION! - THE STRUCTURAL INTEGRITY OF THE MOBILE HOME FLOOR, WALL, AND

CEILING/ROOF MUST BE MAINTAINED.

In addition to the previously detailed installation requirements, mobile home installations must meet the following requirements:

• The heater must be permanently attached to the ﬂ oor.

1. There are two holes in the pedestal base, use 3/8” bolts through the ﬂ oor.

2. To attach the leg model use two 3/8-16 UNC bolts through the ﬂ oor into the two rear legs.

• The heater must be electrically grounded to the steel chassis of the mobile home with 8 GA copper wire using a serrated or star

washer to penetrate paint or protective coating to ensure grounding.

• When moving your mobile home, all exterior venting must be removed while the mobile home is being relocated. After relocation,

all venting must be reinstalled and securely fastened.

• Outside Air is mandatory for mobile home installation. See your dealer for purchasing. (see Ventilation Section for details)

• Check with your local building ofﬁ cials as other codes may apply.

MOBILE HOME

MOUNTING BOLT HOLES