Instruction manual

Breckwell 17

Installation into a Masonry Fireplace:

Multiple installation methods may be available in your

area. Check with local building ofﬁ cials for any permits

required for installation of this unit and notify your

insurance company before proceeding with installation.

Breckwell recommends the use of a full liner where a stainless steel

rigid or ﬂ exible liner pipe is routed from the insert outlet collar to

the top of the chimney.

1. Clean the ﬁ replace opening properly disposing of any ashes in

a closed metal container. See Safety Instructions.

2. Install a 6˝ (152mm) minimum diameter, continuous stainless

steel chimney liner into the existing chimney. The liner must

extend to the top of the existing chimney. Use only listed

chimney liners that meet UL1777 standards. Follow liner

manufacturer installation instructions.

3. Remove or lock the ﬁ replace damper in the open position. Note:

Masonry or damper plate may be removed to accommodate the

chimney liner provided this does not weaken any structural

components of the existing ﬁ replace or chimney nor reduces

protection of combustible materials required by national

building codes. Consult with your local building or ﬁ re authority

before doing this.

4. Uncrate the appliance. Remove all packing materials, and

any items stored in the ﬁ rebox.

5. WARNING: Any ﬁ replace which has had parts removed or

modiﬁ ed to accommodate the installation of this appliance

MUST have a warning plate permanently installed in a

visible location stating that the ﬁ replace is unﬁ t for use with

solid fuel. Permanently attach the warning plate to a visible

location in the ﬁ replace.

6. Position the appliance into the ﬁ replace opening.

7. If necessary, 1/4-20 leveling bolts can be inserted into the

base and used as levelers for uneven ﬁ replaces.

8. Connect the chimney liner to the appliance using a stainless

steel adapter and securing with a minimum of three (3) sheet

metal screws. The liner MUST be attached with the male

(or crimped) end of the adapter inside the ﬂ ue collar of the

appliance to allow condensation and/or creosote to drain

back into the ﬁ rebox.

9. Assemble the Surround. Lay pieces face down on carpet

or other soft surface to protect ﬁ nish during assembly. The

Surround consists of two side panels, a top panel, and a

decorative trim frame.