Instruction manual

Breckwell 5

Unpack and Inspect

Remove the packing from the appliance and inspect for any damage. Your appliance is packed with the door handle in a non-

operational position for shipping purposes.

The correct operating position is with the handle rod pointed towards the ﬂ oor, at an approximate angle as illustrated below.

Ensure that the bricks are positioned correctly and not broken (see illustration for proper brick arrangement). Make sure that the

bafﬂ e board, above the air tubes, is in place and undamaged. (DO NOT REMOVE)

Tools and Materials Needed For Installation

1. You must choose one of the three offered kits:

A) Pedestal Kit (SA740P)

B) Leg Kit (SA740L)

C) Fireplace Insert (SA740i)

Refer to the instructions found inside each kit for proper assembly.

2. A 7/16” socket wrench

3. Ruler / Measuring Tape

4. Furnace Cement

5. A 5/16” socket (Best if using a power drill and a socket bit)

6. A pair of pliers or channel-locks

7. A power drill with an 1/8” drill bit to install sheet metal screws into connector pipe.

8. Sheet metal screws

9. A non-combustible ﬂ oor protector as speciﬁ ed in this manual.

10. All chimney and chimney connector components required for your particular venting installation.

11. For mobile or manufactured home installations, see the MOBILE HOME section in this manual.

Brick Conﬁ guration

Door Handle Proper Operational Position