Instruction manual

Breckwell 7

1.50

RETAINING SCREWS

BEHIND INSULATION

CUT HERE

PULL BACK INSULATION

Front Plate (26302)

Insulation (88190)

Damper Plate (26304)

Air Dam (26346)

Air Dam Removal

For ﬁ replace insert models, an air dam must be removed from the front of the stove.

1. On the front of the stove remove the two (2) screws holding the front plate(26302) in place.

2. Next make two cuts in the insulation(88190) measuring 2.5”(63mm) and 1.5”(38mm) as shown.

CAUTION: The insulation is held in place with sharp retaining studs. Use caution when removing the

insulation to avoid injury.

3. Pull back the insulation from the cuts and remove the damper plate(26304), air dam(26346), and the two retaining screws(83343)

located behind the insulation.

4. Reinstall the damper plate(26304) and retaining screws(83343).

5. Finally reinstall the front plate and the two retaining screws.

FIREPLACE INSERT ASSEMBLY